Ubiquiti Networks Community Knowledge Base - Ubiquiti Networks Community TOUGHSwitc h (17 Articles) TOUGHSwitc h - How to enable, disable or cycle POE via SSH TOUGHSwitc h - Multicast Support TOUGHSwitc h - How to enable POE output on one Ethernet port? TOUGHSwitc h - How to change the ToughSwitc h IP address ...
Re: Air Cam Bricked - Ubiquiti Networks Community I received a brand new Air Cam and was logged in through a browser. We set it to 1fps and was adjusting the brightness, when it bricked.
Bricked AirCam Recovery Notes - Ubiquiti Networks ... 2013年10月22日 - Hi Guys, Just wanted to post instructions for recovering an AirCam from scratch using windows 7 and TFTP via Command Prompt. This guide ...
Re: Air Cam Bricked - Ubiquiti Networks Community The camera was used inside the house. At what time it stopped working. does not get ip and does not work with the default ip. In this case ...
Aircam bricked after firmware upgrade...? What do I do now ... Hello, after a long time, we installed two aircams on a remote mountain connected with a wireless network (nanobeams). These units had a ...
Bricked airCam - Ubiquiti Networks Community So we have a bricked airCam Dome in our hands. There is nothing to be wrong with initial setup of 24 cams but after 3 months there was...
Bricked('ish) AirCam Mini - Ubiquiti Networks Community I picked up two AirCam Minis for evaluation a while back (over a year if I remember correctly). I was reconfiguring the IP camera viewer on my ...
Aircam lockup - brick - Ubiquiti Networks Community 2012年7月23日 - I recently found the resonably priced aircams and aircam domes and decided to replace the old outdated dlink cams that I had. Started with one ...
AirCam Mini Bricked? - Ubiquiti Networks Community I just got a new AC Mini tonight and went about seting it up and adding it to my AirVision install. AirVision told me the camera would need a firm.
Can't Ping Bricked Air Cam - Ubiquiti Networks Community I did the 'hold down reset while powering up' and kept it held for 10 & 15 seconds. No Joy. I keep getting the 'unreachable' message while ...
